Save cpu

wasn’t there a way with switching a hole part of the patch to off/hold?! I tried select and switch but that hadn’t worked!

if you take a switch for on/off and connect to pin 0 (the off part) a select node where bin size is 0, you get an NIL out of the select which shut down the following circuit.
Handle it with care as same nodes are quite sensible to that. If you want to filter this NIL out in later part, then take a + (spectral) and after it “>” 0, which controls a switch to open or close datastream. “+ (spectral)” interprets NIL as 0! So if it isnt 0 it opens the switch. Or you can take a count.node instead of “+ (spectral)”.