NextWindow strange issue

hi, i’m using the fantastic plugin by vux with my dellsx2210t. All works fine (except the fact that when i use the vux plugin and then i close vvvv, multitouch don’t go in the operating system until restart or reset the panel to the default setting. But now, i have buyed a new multitouch monitor (52’) based on the same nextwindow technology. Installed the drivers, tried the patches i made, all is ok, but sometimes (without a reason, apparently) the operating system takes the control of the touch input, and vvvv loose it, until i restart vvvv. This is a problem because all the application i wrote works just for a few minutes and the stops to run. Any idea of why?

ps. difficult to explain this observation, but, if i use the plugin, after a while windows take the control, and the pointe of windows is piloted by multitouch, but if i use the plugin, and the i close vvvv when it’s running, windows don’t take the “focus” (same as the dell). So i can exclude a sort of driver monitoring that retake the controls after an application takes it instead

thanks to a cross debugging with vux, i found the cause of the problem, and probably the solution (for now it works). The problem was caused by the optional software from nextwindow that i installed in this pc, and not in the pc attached to dell (at home). The problem was cause by a property inside the usb config software, (mouse interface) setted by default as usb hid mouse. So, for resolving this issue you have two way: not install the optional tools, or setting this property to none (because this optional sofware could be useful for configuring and calibrating the device, i prefer to install it and disable the mouse emulation)

but the best thing is that the vux plugin is not bugged :D great vux!!